VOO POO - Drag Q Pod System

EAN code

Only %1 left

This product is unfortunately no longer available. You are sure to find a cool alternative in our online store!

Overview

The Drag Q Pod Kit from Voopoo comes in the familiar Drag design in a new, smaller size. Compared to its predecessors, the Voopoo Drag Q is lighter and smaller and looks elegant thanks to its round pod that resembles a vaporizer and its tall body.

Details

The Drag Q Pod Kit comes in its familiar design, but even smarter and more compact (92.5 mm x 24 mm x 14 mm) and provides unforgettable vapor moments.

With its pleasant silicone and leather cover and the zinc alloy, the Drag Q ensures greater comfort.

The Drag Q is perfect for a tight MTL or RDL draw.

Voo Poo has equipped this system so you can simultaneously regulate the airflow and power (8 to 25W).

The settings are made precisely on the ring for an incredible taste experience.

The air intake is very innovative in a half-moon shape and is located on the top of the battery. Thus, the air inlet is not disturbed by your hand. This prevents the overheating of the mouthpiece, as well as the bursting of the eLiquid, which is caused by the lack of airflow.

The GENE chipset ensures steaming without worrying . It provides 6 protections in case of too long vapor time, short circuit, overheating, overload, low voltage, overcurrent at the output.

The Pod locks itself after 5 minutes of inactivity to prevent accidental triggering.

To unlock, you simply have to drag directly or just press 3 times on the switch.

Battery life

The 1250 mAh battery can be quickly recharged thanks to the included USB-C cable. The charge level is displayed in color on the light bar:

- Green : 60 to 100%

- Blue : 25 to 60%

- Red : less than 25%

The ITO-X Pods from Voopoo for even more eLiquid

The magnetic ITO-X pods made of PCTG and stainless steel with 3.5 ml tank volume are compatible with ITO coils (2 are included). The filling is done from the top by unscrewing the top cap.

- ITO M0 vaporizer head 0.5 Ohm (mesh of Kanthal) : RDL draw resistance - use between 18 and 25 W - mix ratio 50PG/50VG.

- ITO M3 vaporizer head 1.2 Ohm (Mesh of Kanthal) : tight MTL draw resistance - between 8 and 12 W - mixing ratio 80PG/20VG to 50PG/50VG - compatible with nicotine salts, CBD and increased nicotine content.

- ITO M1 vaporizer head 0.7 Ohm (mesh of Kanthal) : tight MTL draw resistance - between 14 and 18 W - mixing ratio 80PG/20VG to 50PG/50VG

- ITO M2 vaporizer head 1.0 Ohm (Mesh of Kanthal) : tight MTL draw resistance - between 10 and 14 W - mixing ratio 80PG/20VG to 50PG/50VG - compatible with nicotine salts, CBD and increased nicotine content.

The change of the coil is very simple. Simply pull out the old coil, light the new coil and push it into the slot.

Wait 10 minutes before you start steaming.

Note that you need to replace your coil about every 2 weeks depending on your use. Remember to replace your coil when they change taste or perceive a burnt flavor.